ENTHALPIES OF SOLUTION AND HYDRATION


This page looks at the relationship between enthalpies of solution, hydration enthalpies and lattice enthalpies.


Note:  You really ought to have read the pages about Hess's Law cycles and lattice enthalpies before you continue with this page.



Enthalpy change of solution

Defining enthalpy change of solution

The enthalpy change of solution is the enthalpy change when 1 mole of an ionic substance dissolves in water to give a solution of infinite dilution.

Enthalpies of solution may be either positive or negative - in other words, some ionic substances dissolved endothermically (for example, NaCl); others dissolve exothermically (for example NaOH).

An infinitely dilute solution is one where there is a sufficiently large excess of water that adding any more doesn't cause any further heat to be absorbed or evolved.

So, when 1 mole of sodium chloride crystals are dissolved in an excess of water, the enthalpy change of solution is found to be +3.9 kJ mol-1. The change is slightly endothermic, and so the temperature of the solution will be slightly lower than that of the original water.


Thinking about dissolving as an energy cycle

Why is heat sometimes evolved and sometimes absorbed when a substance dissolves in water? To answer that it is useful to think about the various enthalpy changes that are involved in the process.

You can think of an imaginary process where the crystal lattice is first broken up into its separate gaseous ions, and then those ions have water molecules wrapped around them. That is how they exist in the final solution.

The heat energy needed to break up 1 mole of the crystal lattice is the lattice dissociation enthalpy.

The heat energy released when new bonds are made between the ions and water molecules is known as the hydration enthalpy of the ion.

The hydration enthalpy is the enthalpy change when 1 mole of gaseous ions dissolve in sufficient water to give an infinitely dilute solution. Hydration enthalpies are always negative.

Factors affecting the size of hydration enthalpy

Hydration enthalpy is a measure of the energy released when attractions are set up between positive or negative ions and water molecules.

With positive ions, there may only be loose ion-dipole attractions between the δ- oxygen atoms in the water molecules and the positive ions, or there may be formal dative covalent (co-ordinate covalent) bonds.

With negative ions, ion-dipole attractions are formed between the negative ions and the δ+ hydrogens in water molecules.


Note:  You will find the attractions between water molecules and positive ions discussed on the page about dative covalent bonding.

An ion-dipole attraction is exactly what it says. There is an attraction set up between the positive or negative ions and the oppositely charged δ- or δ+ parts of the polar water molecules.



The size of the hydration enthalpy is governed by the amount of attraction between the ions and the water molecules.

  • The attractions are stronger the smaller the ion. For example, hydration enthalpies fall as you go down a group in the Periodic Table. The small lithium ion has by far the highest hydration enthalpy in Group1, and the small fluoride ion has by far the highest hydration enthalpy in Group 7. In both groups, hydration enthalpy falls as the ions get bigger.

  • The attractions are stronger the more highly charged the ion. For example, the hydration enthalpies of Group 2 ions (like Mg2+) are much higher than those of Group 1 ions (like Na+).


Estimating enthalpies of solution from lattice enthalpies and hydration enthalpies

The hydration enthalpies for calcium and chloride ions are given by the equations:


The following cycle is for calcium chloride, and includes a lattice dissociation enthalpy of +2258 kJ mol-1.

We have to use double the hydration enthalpy of the chloride ion because we are hydrating 2 moles of chloride ions. Make sure you understand exactly how the cycle works.

So . . .

ΔHsol = +2258 - 1650 + 2(-364)

ΔHsol = -120 kJ mol-1

Whether an enthalpy of solution turns out to be negative or positive depends on the relative sizes of the lattice enthalpy and the hydration enthalpies. In this particular case, the negative hydration enthalpies more than made up for the positive lattice dissociation enthalpy.


Important:  This diagram is basically just to show you how to do these calculations, but I have no confidence whatsoever in the accuracy of the data I have used. The measured value for the enthalpy of solution for anhydrous calcium chloride (the value which we are trying to calculate here) is about -80 kJ mol-1. That bears little relationship to the value calculated here!

I have no idea what the source of this discrepancy is. One or more of the figures I am using is obviously inaccurate. Trying to find reliable values for energy terms like lattice enthalpies or hydration enthalpies has been a total nightmare throughout the whole of this energetics section. Virtually every textbook I have available (and I have quite a few!) gives different values. Virtually every textbook that you can access via Google Books has different values. Virtually every website that you look at seems to have its own combination of values which may or may not agree with any of the books.

Despite the fact that I am now totally fed up with this whole topic, it shouldn't affect you as a student or a teacher working towards an exam the equivalent of UK A level. You have to work with whatever values your examiners give you. What is important is that you understand what you are doing. As long as the answer you come up with is consistent with the data you are given, that is actually all that matters to you.




Questions to test your understanding

If this is the first set of questions you have done, please read the introductory page before you start. You will need to use the BACK BUTTON on your browser to come back here afterwards.

questions on solution enthalpies

answers


Where would you like to go now?

To the chemical energetics menu . . .

To the Physical Chemistry menu . . .

To Main Menu . . .



© Jim Clark 2010 (last modified October 2018)